質問：
When connecting the audio from TSG95 to the WFM90 series or to the VM700T+ the audio level reads high. Why?
回答：
The TSG95 audio level is specified into a 600 Ohm load. The load of the WFM90 or VM700T is >15 K ohms and the impedance mismatch results in the audio reading about 1dB high.
The solution is to add a 600 Ohm resistor across pins 2 and 3 in the audio cable XLR connector that goes to the WFM90 or VM700T. This is shown in theTSG95 service manual in the performance verification procedure.
FAQの該当製品：
製品シリーズなし
製品：
FAQ ID 62311
すべてのFAQを表示 »