How do I set up a Ethernet bus decode

Question:

How do I set up an Ethernet bus decode?

Answer:

Make sure your setup is prepared to decode, that you have the needed probes, scope options, test boards, etc. Once you have the options it's important to know how to use the options and probe your signal. To setup Ethernet bus decoding, turn on your bus, set the input channel, select the data rate. Next you set your threashold levels since Ethernet has three levels you have to select high and low. Watch this short video to see how to setup Ethernet bus decode and how to trigger. 

 

This FAQ Applies to:

Product Series: MSO4000 / DPO4000, MDO3000, MDO4000

Applications: Ethernet Test

Product: DPO4014B, DPO4032, DPO4034, DPO4034B, DPO4054, DPO4054B, DPO4102B, DPO4102B-L, DPO4104, DPO4104B, DPO4104B-L, DPO4ENET, MDO3012, MDO3014, MDO3022, MDO3024, MDO3032, MDO3034, MDO3052, MDO3054, MDO3102, MDO3104, MDO4014-3, MDO4014B-3, MDO4024C, MDO4034-3, MDO4034B-3, MDO4034C, MDO4054-3, MDO4054-6, MDO4054B-3, MDO4054B-6, MDO4054C, MDO4104-3, MDO4104-6, MDO4104B-3, MDO4104B-6, MDO4104C

FAQ ID : 64731

View all FAQs »
ダウンロード
ダウンロード

マニュアル、データシート、ソフトウェアなどのダウンロード:

Go to top